A couple years ago I picked up some Autel MX Sensors which support "cloning" through their diagnostic tool. Then I cloned my summer tire TPMS IDs to be the same TPMS IDs as my winter tires, and now I can swap them seasonally in only a few minutes with no need to make the car relearn them.
NextDNS has a "Cache Boost" option that, when enabled, clamps answers to a minimum TTL to mitigate things like this. I've noticed that some Samsung IoT domains also have aggressively low TTL.
Here's a doctor who made some humorous observations about how AI is being used by their peers in writing suddenly-coherent patient notes: https://youtu.be/WgnWgIOer6s
I thought WW-style was mostly hot desks or hot offices? I was thinking something semi-permanent with additional privacy. Maybe that exists and I’m out of the loop.
Then you'll probably wind up using the same 3 or 4 glues for everything. Actually almost everyone will do that because few have a magnificent glue collection.
Super glue, shoe goo, and epoxy are going to give pretty good bonding for their use cases but are more toxic.
Hot glue and titebond III seem to be safe-ish(Hot glue doesn't exactly smell very healthy when you use it though!) But require technique and experience to use and know what stuff to not even try using them with.
And gorrilla tape is probably good enough half the time.
UV glue I just don't have any experience at all with, but it seems to be gaining popularity. Just don't use the nail polish and blast your hands with UV too much!
Mechanical fastening is usually least toxic and often stronger.
Paper or hemp cord willer or wrapping is often helpful.
But my favorite of all is to design things such that you're not putting lots of forces on a joint in the first place, then it's less important how you make said joint. Look at a basic ugly cinder block and scrap wood shelf. The load goes straight down compressing the blocks, gravity is doing most of the work here, so friction holds it together.
A few months ago I was able to bypass creating an account (and sidestepping all the dark patterns) by just calling their automated phone number and unfreezing with my PIN. Was pretty painless.
Phil's Lab is a really detailed channel covering multilayer PCB design skills. He shares a lot of nuance that would be gained only through years of trial/error or an apprenticeship.
Love watching PhilsLab - I dabble a bit with PCB design on my own YouTube channel and the difference between an amateur tinkerer (me) and someone who is an expert in it is amazing.
